#Ffmpeg mac mini i7 drivers#
#Ffmpeg mac mini i7 full#
#Ffmpeg mac mini i7 windows#

The Bootcamp Win10 20H2 (latest build) runs at 4K/2160p resolution with 125% DPI scaling, latest NVIDIA drivers installed, V-SYNC remained switched on.įirst I mention the used Benchmark tool and the settings/preset, second the score points and/or FPS for the RTX 3080, last the performance gain in percent compared to the 2080Ti (used the score for calculation, if not present I took FPS value).

#Ffmpeg mac mini i7 windows#

This display selection has to be done only once (first connection). Have to mention, that I have another connection to the same display via USB-C to DP-Port adapter (iGPU in Mac mini) to use it in MacOS, this adapter is used during boot process and at login screen (and therefore Windows shows two monitors).ĭid some benchmarking with the 'old' RTX 2080Ti and the new RTX 3080 to compare performance. The eGPU gets recognized and produces output on DP, then I switch to display settings and select exclusive monitor output to second screen (external monitor only). Pray that there's no blue screen appearing (50/50 chance), otherwise reboot again (don't forget to switch eGPU off before) -> Btw, does anyone know a better way to deal with that? Booting into Win10 by holding option key during startup, select bootcamp partition, log into Windows, wait about 10 seconds and then hot plug the eGPU.

#Ffmpeg mac mini i7 drivers#

Having an installed Win10 20H2 (latest build) with latest NVIDIA drivers for RTX 3080 installed, too. I just unpack the new Box, connected power cable and my existing DP cable and a longer TB3 cable (previously used), because the provided TB3 cable is much to short for off desk use. The unboxing / connecting was very straight forward and plug & play because of my existing setup with the previous model, same configuration and drivers used. That's not much louder than normal background noise, so quite good I think!

#Ffmpeg mac mini i7 full#

Together with my housing the setup is barely hearable under full load (36db at my sitting position and around 40db directly measured next to the Box (front)). This might be due to the fact that the cooling technology has been improved or the GPU does not really reach the 100% load, maybe TB3 bottleneck? Any ideas? -> already confirmed that the RTX 3080 runs a few degrees cooler than RTX 2080 Ti and therefore produces less noise overall. It has to be said that the Gaming Box RTX 3080 itself is really very quiet when directly compared to the RTX 2080 Ti, even under full load the fans never turn up as loud as they did in the old box before.

I'm not much of a craftsman, but this was fun to make and I think it turned out pretty well - not to mention it serves its purpose just fine. I left a vent open at the back of the case where the cold room air is sucked in and the front fan blows the warm air out. This guy is really quiet, even at 10V (out of a maximum of 12V, what I never use) it's barely audible.

I added some insulation/acoustic foam inside and installed a Noctua NF-P14s redux-900 fan including a power supply with adjustable voltage. I also took a chance and built a soundproof case that allows me to banish the Gaming Box from my desk. I used my Mac mini (latest Intel-based Mac mini from 2018, maxed out to 64GB RAM) w/Win10 20H2 (latest build) running at Bootcamp partition to test the new monster. System specs + eGPU hardware + Hardware pictures My new RTX 3080 Gaming Box arrived yesterday, replaced my 'old' RTX 2080 Ti Gaming Box and I like to share some details with you.